Daikin Clima-Flex CLIV Series Control Manual page 8

cm-cliv-cf-eng
HP1= High Pressure Alarm
The unit is operating at High Pressure. As soon as the pressure is
reduced the Alarm will automatically reset.
LP1=Low Pressure Alarm
The unit is operating at Low Pressure. As soon as the pressure
rises the Alarm will automatically reset.
TP= Thermal Circuit Breaker
Alarm phase with voltage problems. The protection motor sends
a signal to open the circuit breaker, it will automatically reset once
the problem has been solved.
FL=Flow Alarm
The Flow Alarm is activated when Low Flow is detected, to reset
the alarm and correct the problem: Reset the unit (Turn the unit off
and on).
A1=Freeze Alarm
Temperature sensor B3 measures a temperature lower than the
programmed value. The alarm will reset once the temperature
value rises.
ON-SCREEN TEMPERATURE
To enter the temperature on the display, navigate using the Up/
Down keys.
The default set temperature is B02= Injection Temperature.
Using the navigation keys, it is possible to move to B01 = Return
temperature display and B03= Freezing temperature display.
These temperatures will be displayed, if no key is pressed for a
few seconds the display will return to the initial screen.
8
Control
www.clima-flex.com