Daikin Clima-Flex CLIV Series Control Manual page 10

DISPLAY
Legend
1 Keyboard
2 Main field
3 Device status and operating mode icons
The display only allows access to some User and Support level
parameters: to access all the Support and Manufacturer parameters
it is necessary to use the Carel Applica app or the configuration and
commissioning tool.
KEYBOARD
KEYPAD
• In navigation: Access to the preceding
• In programming: Value increment
• In navigation: Access to the following parameter
• In programming: Value reduction
• Short press: Display of the main screen of the unit
• Long press (3 s): access to User level parameters
(set point, on-off unit,...)
• Short press: display of the active alarms and
silencing of the buzzer.
• Long press (3 s): alarm reset.
• In navigation: access to parameter programming.
• Short press: value confirmation.
• Long press (3s): return to main menu.
cm-cliv-cf-eng
FUNCTION
ICONS
The icons indicate the operating status of the devices and the
operating mode, as shown in the following table.
Icon
Description
System pump
Status of source
devices (pump
/ fan)
Compressor
status
Anti-freeze
resistor
Operation mode
Free cooling
exceeding the
Assistance
operating hours
Standard Display Visualization
At startup, the user terminal briefly displays the text "NFC", which
indicates the presence on the user terminal of the NFC interface for
communication with mobile devices, and then the standard display.
The standard display shows:
• In the top row: the flow water temperature;
• In the bottom row, with the unit switched on, the return water
temperature. With the unit switched off, the "OFF" status.
during "Bluetooth" communication, the text "bLE" flashes on
the display.
Main screen
From the main menu, press DOWN to access information on the
status of the devices and on the values of temperature, overheating,
etc. of the two circuits:
• Unit "OFF" and cause of shutdown:
• "diSP" by keypad;
• "dI" for remote contact (via digital input);
• "Schd" for time slot (scheduler);
• "bMS" for BMS;
• "ChnG" for change of operating mode (heating/cooling);
• "AlrM" for alarm.
• "CM" for compressors;
• "AFC1" for flow water temperature source circuit 1;
• "AFC2" supply water temperature, circuit 2;
• "EuP1" evaporating temperature circuit 1;
• "SSH1" circuit 1 overheating;
• "Cnd1" circuit 1 condensing temperature;
10
Control
Status Mode of operation
Active In manual operation
Active In manual operation
Active In manual operation (with ExV)
Active -
Heating -
Cooling High water tem. High water tem.
Defrost Dripping after defrosting
-
Demand for Serious alarm, request for
qualified personnel to intervene
threshold
www.clima-flex.com