Table of Contents
Advertisement
8.0 POSITIONING THE UNIT (Continued)
FIG 8-2b
8.3
Once the unit is properly positioned, ensure rear axle is parallel to the leading edge, raise the handle to lower
the frame to the substrate, and deploy the outriggers. FIG 8-3
(8.3.C) SLOWLY RAISE
HANDLE TO LOWER
THE UNIT TO THE
SUBSTRATE
(8.3.A) APPLY &
MAINTAIN DOWNWARD
PRESSURE
(8.3.B) PULL OUT TO
RELEASE HANDLE
(8.3.D) PULL T-HANDLE PINS
(x4) TO LOWER OUTRIGGERS
X-C
I
ALIBUR
NSTRUCTION
8.3.A
To lower the X-CALIBUR frame to the 'frame down, brake position', apply &
maintain pressure on the handle with one hand.
8.3.B
While maintaining handle pressure with one hand, use your other hand to pull
the locking pin out and release the handle.
8.3.C
Slowly raise the handle to lower the X-CALIBUR frame to rest
securely on the substrate in the 'brake position'.
8.3.D
Pull T-Handle Pins to unlock and release outriggers, lower
outriggers to the substrate until T-Handle Pins lock the
outriggers in the deployed position.
M
ANUAL
14
E
N
G
L
I
S
H
FIG 8-3
Advertisement
Table of Contents
