Table of Contents
Advertisement
6.0 GENERAL SAFETY (Continued)
E
6.8
Only use the X-CALIBUR on completed roof assemblies for which it has been tested. (Reference Sect 4.2
N
Approved Substrates)
G
6.9
Always lower the unit using the locking handle so the frame is resting on the substrate when not in use.
L
I
6.10 Always use caution and common sense when moving the unit. Additional workers may be needed to safety
move the unit when additional materials, tools or equipment have been added to the unit.
S
H
7.0 BEFORE EACH USE
7.1
Before using this unit, a rescue plan and procedure in accordance with OSHA Standards must be in place to
ensure prompt rescue in the event of a fall.
7.2
Inspect the unit for any damage. A maintenance log has been
provided in this manual that may be copied and used to track
inspections and damage.
7.2.A
7.2.B
7.2.C
7.2.D
7.2.F
Mechanism is in the proper spring loaded position using
the viewing window. FIG 7-2-F
7.2.G DO NOT USE DAMAGED EQUIPMENT OR
8.0 POSITIONING THE UNIT
8.1
Verify that the substrate the unit is to be used on is acceptable (Reference Sect 4.2 Approved Substrates) and
the entire working surface has the strength and structural integrity to safety support both the workers and the
unit.
8.2
Position the unit with the Fall Arrest
Attachment Point side 12' - 15' away and
parallel to the working edge to maximize the
work zone. FIG 8-2a
The unit may be used a minimum of 4' from
the leading edge, maintaining a maximum
work zone of 45˚ or 2' from the center of the
attachment point. FIG 8-2b
The unit may be used a maximum of 30'
from the leading edge, however the work
zone may not exceed 15' from the center of
the attachment point. FIG 8-2b
X-C
ALIBUR
Check for loose, bent or damage parts, including the talon
and rake tips of the engagement arm. FIG 7-2
Check welded connections for visible distortion, cracks or
other damage.
Check Attachment Point for distortion or damage.
Ensure all safety labels are present and fully legible.
(Reference parts list pages 5-9)
Ensure the Engagement Arm Locking
EQUIPMENT THAT HAS BEEN MODIFIED.
I
M
NSTRUCTION
FIG 7-2-F
13
ANUAL
FIG 7-2
RAKE
TALON
VIEWING
WINDOW
FIG 8-2
Advertisement
Table of Contents
