Switching A Route Using The Built In Control Panel - Blackmagicdesign Videohub 12G Installation And Operation Manual

Switching a Route using the Built in Control Panel

Switching a route is as simple as selecting the destination output and then selecting a source
input to route to it.
Selecting the Source and Destination
1 Press the 'out' button to enable the destination output selection.
2 Press a numbered pushbutton to select a destination output. Alternatively, you can use
the search dial to scroll through the destinations.
3 Now press the 'in' button to enable the source input selection.
4 Press a numbered pushbutton to select a source input. Alternatively, you can also use the
search dial. When the source is selected, the 'clear' and 'take' buttons will flash indicating
that you can confirm the route by pressing take, or cancel the route by pressing clear.
EDIT CAM STREAM COMP SWITCH
2 3 4 5 6
You can also use the search dial to select your source and destination
MON DECK EDIT CAM STREAM
1 2 3 4 5
DECK EDIT CAM STREAM
MON
1 2 3 3 4 5
DECK EDIT CAM STREAM
MON
1 2 3 4 5
DECK EDIT CAM STREAM
MON
1 2 2 3 4 5
KEY ST/C M/VIEW IN IN
7 8 9 0 OUT
COMP SWITCH KEY ST/C M/VIEW
6 7 8 9 0
COMP SWITCH KEY ST/C M/VIEW
6 7 8 9 0
COMP SWITCH KEY ST/C M/VIEW
6 7 8 9 0
COMP SWITCH KEY ST/C M/VIEW
6 7 8 9 0
CLEAR CLEAR
TAKE TAKE
IN CLEAR
OUT OUT TAKE TAKE
IN CLEAR CLEAR
OUT OUT TAKE TAKE
IN IN CLEAR
OUT TAKE TAKE
IN IN CLEAR CLEAR
OUT TAKE TAKE
MENU
SET
LOCK
Getting Started
MENU
SET
LOCK
MENU
SET
LOCK
MENU
SET
LOCK
MENU
SET
LOCK
8