Turning On The Handheld; Establishing A Wireless Connection - Palm Tungsten Tungsten W Getting Started

Turning on the handheld

This problem may occur during Step 2.
Problem: Handheld does not turn on.
If your handheld has been charged for at least two hours and it seems
not to turn on when you press the power button, try the following:
Press the Date Book application button
button to ensure your handheld is turned on.
Press Function
dialog box appears, adjust the brightness by pressing and holding
Up on the navigator for a few seconds. If this doesn't work, press
and hold Down on the navigator for a few seconds.
If your handheld was exposed to cold, make sure it is at room
temperature before you turn it on.
Perform a soft reset: Unscrew the top of your stylus to access the
reset tool (or use an unfolded paper clip or similar object without a
sharp tip). Gently press the reset button inside the hole on the back
panel of your handheld.

Establishing a wireless connection

This problem may occur during Step 4.
Problem: Signal strength is weak.
Using the Signal Strength bar graph, monitor the signal strength while
you try the following solutions.
and then Brightness
Reset button
Troubleshooting
or any other application
. If the Brightness
25