Advertisement
Step
Installation
1
1-1. Remove the mounting plate
1
2
1-3. Connect cables to device.
NOTE
Only the connector can be fixed
inside the body with double-sided
tape. The LAN connector must be
stored in the wall.
DC power cable
12 V DC power for camera and PIR
The default network type of InSight is dynamic.
If you have a DHCP server, it will automatically set the InSight.
Step
2
IP address settings
If you do not have a DHCP server, it will set as follows after one minute.
Initial address: Refer to the label on the InSight
User name: root
Default password: OPTEX
Change your password as appropriate.
Download IP installer;
https://navi.optex.net/firmware/50427
Refer to the "InSight IP camera install manual" for more details;
https://navi.optex.net/manual/50427/en/?type=cameramanual
Step
Camera angle and PIR area settings
4
Changing for each item in this step is optional.
Check the default settings and if no changes are required, proceed to the next item.
Further information, refer to the "INS-HX-80N Full manual" on the Web.
INS-HX-80N Full manual
https://navi.optex.net/manual/50427/en/?type=installationinstructions
1-2. Install the mounting plate using 2 screws
3
8-pin I/O cable
Pink
Orange
Yellow
Brown
Green
Purple
Black
Red
PoE LAN
cable
Jump to Step 3
InSight Camera manual
To pass cables through the wall, drill a 25 mm (1") or larger hole in the wall.
NOTE
Use a single gang box for exposed wiring.
Tamper
Alarm
Caution
Do not connect to the N/A terminal.
It can be also used as a back up
Power
for POE
Waterproof cap
for LAN connection
Refer to the Web manual how to use the cap.
Step
3
Device registration to CHeKT portal
Setup your CHeKT Dealer Portal:
1. Go to http://dealer.chekt.com/ to log in.
2. Select the Customer on the left side of the dashboard.
3. Select the Site Devices tab.
4. Select the bridge device to be associated with the sensor camera.
5. Access the bridge settings using the gear icon to its right.
6. Select the appropriate tab to register the PIR camera.
Refer to the site for more details.
4-1. Horizontal adjustings
Remove the Back cover.
1
Raise up
1
2
Hook the fall prevention wire.
Caution
1-4. Secure the main body
1
2
Put the main body back on the mounting plate.
Caution
Do not pinch the cables during assembly.
CHeKT suppor
https://support.chekt.com
Adjust horizontal angle.
2
2
Pull back
Horizontal: ±95°
NOTE
Only one side needs to be loosened.
Advertisement
