Advertisement
using your stand mixer
To attach HeatSplash
TM
1.
Rotate Control Dial to off position "0" to turn unit off.
2.
Unplug Stand Mixer.
3.
After bowl and accessory are assembled to mixer, Gently lower mixer head,
ensuring it locks in downward position. A "click" sound will indicate the mixer
head has locked securely into position.
4.
From the front of the mixer, slide the HeatSplash™ Guard over the bowl and
accessory until it is centered. The inner ring of the HeatSplash™ Guard should
fit over the outer rim of the bowl. Note: The HeatSplash™ Guard must be
placed over both heat nozzles (Figure E).
4
5
3
6
2
1
10
VFM027_22EM1 (UK).indd 10-11
VFM027_22EM1 (UK).indd 10-11
Guard
7
8
9
10
Figure E
using your stand mixer
To use HeatSplash
Guard
TM
1.
When using HeatSoft™ Technology, use HeatSplash™ guard for best results.
2.
While securing HeatSplash™ Guard with one hand, pour the ingredients into
the bowl through the pouring chute.
To remove HeatSplash
Guard
TM
1.
Rotate Control Dial to off position "0" to turn unit off.
2.
Unplug Stand Mixer.
3.
Lift the front of the HeatSplash™ Guard clear of the bowl rim and pull forward.
LED light
This stand mixer has an LED light on the mixer head (Figure F). The LED light allows
for better visibility of the mixture to ensure desired consistency. The LED light will
switch on automatically when the mixer is in operation and automatically switch off
when the mixer is not in use.
Figure F
11
2022/4/6 8:49 AM
2022/4/6 8:49 AM
Advertisement
