Introduction To Your New; R 2 Dice • R 2 Ultra Dice; Switching On The Machine; Advice On Electrical Connections - Robot Coupe R 2 Dice User Manual

INTRODUCTION TO YOUR NEW

R 2 Dice • R 2 Ultra Dice
The R 2 Dice / R 2 Ultra Dice is a versatile machine
designed to meet your professional needs. It can
perform a number of tasks, as well as save much in
time and labor.
This food processor consists of a bowl assembly
and a vegetable preparation attachment. The 3
quart bowl is used for chopping, grinding,
pureeing, blending, mixing, and kneading
ingredients used in most recipes.
A wide range of cutting plates are available for use
with the vegetable preparation attachment. Cutting
plates are available for slicing, waved slicing,
grating, pulping, julienne and dicing.
Its numerous functions will open the door to a whole
new culinary world.
Thanks to its simple design, all components
requiring frequent handling for maintenance or
cleaning can be easily assembled or removed.
All users should read this operation manual before
operating the machine.
SWITCHING ON
THE MACHINE

• ADVICE ON ELECTRICAL CONNECTIONS

Before plugging in, check that your power supply
corresponds to that indicated on the machine's
serial number plate.
W A R N I N G
This appliance must be plugged into an
grounded socket (risk of electrocution).
6
21/09/2020

• CONTROL PANEL

R 2 Dice / R 2 Ultra Dice
Red knob = Off switch
Green knob = On switch
Black knob = Pulse control

• BOWL ATTACHMENT

1) With the motor base
facing you, place the
bowl onto the motor
base with the handle
toward the front. Turn
the bowl just off-center
and to the left as you
lower it onto the base.
2) Then, turn it back
to the right, (counter-
clockwise) locking it onto
the motor base tabs.
3) Place the blade onto
the motor shaft. Rotate
the blade until it drops
into place. The bottom
blade should be level
with and just off the
bottom of the bowl.

ASSEMBLY

The device is now ready for use.

• VEGETABLE PREPARATION ATTACHMENT

The vegetable preparation attachment consists of
two main detachable parts: the continuous feed
attachment and the continuous feed lead.
1) With the motor base
facing you, fit the conti-
nuous feed attachment
onto the motor base; the
exit chute should be at
the rear of the machine.
4) Note the plastic tab
on the bowl lid. Place
the lid on the bowl with
the tab turned to the
front and slightly to the
left of the bowl handle;
then, turn the lid back to
the right until it comes to
a stop with the tab over
the bowl handle.