Operating Instructions; Bowl Attachment - Robot Coupe R 2 Dice User Manual

2) Turn the attachment
to the right until it locks
onto the motor base
tabs.
3) Place the discharge
plate onto the motor
shaft. It should fall into
place just off the bottom
of the continuous feed
attachment.
USING A REGULAR PLATE:
4) Place the cutting plate
of your choice onto the
discharge plate. It may
be necessary to rotate
the plate until it drops
fully onto the discharge
plate.
Follow step 5.
USING A DICING ASSEMBLY :
4a) If you have chosen to dice, position the dicing
grid in the continuous feed attachment.
The grid can be positionned in only one way.
The blades should be visible trough the feed lead
opening.
4 b ) N e x t p l a c e t h e
appropriate dicing plate
onto the discharge plate
and screw the butterfly
nut tight on the motor
shaft.
To dice carrots or hard
vegetables, we advise
you to use the small
cylindrical opening.
Use the slot in the bottom
of the carrots pusher
to unscrew the
butterfly screw.
5) Place the continuous
feed lead onto the conti-
nuous feed attachment,
and rotate it back to the
right until it locks onto
the bowl tabs.
OPERATING
INSTRUCTIONS
• THE UNIT SHOULD BE OFF EXCEPT WHEN
PROCESSING IS UNDERWAY
It is recommended that the machine be operated on
a 50 % duty cycle. This is easily accomplished since
the preparation time (cleaning, coring, peeling, and
loading) takes longer than the processing time. This
will yield the longest life for your machine.

• BOWL ATTACHMENT

The cutter bowl is used for grinding, kneading,
pureeing, blending, mixing, and emulsifying. Before
placing the product into the bowl, some products
such as meats and cheeses should be precut into
1-2 inch portions. When filling the bowl, allow
space above the product for circulation.
There are two ways to run your machine: chopping,
using a quick start/stop action with the Pulse button
or running continuously for a fine chop or puree.
To obtain a uniform chop of products such as meats
and cheeses, begin with a uniformly portioned
product.
7
21/09/2020