Replacing the Camera Module
1. Place the camera module (A) into its compartment on the LCD cover and secure it in
place with adhesives. Make sure that the aperture on the camera module is aligned
with the stud (D) located on the LCD cover
2. Connect the camera cable (C) to the camera connector (B)
NOTE:
NOTE:
Use care not to damage the cable.
NOTE:
NOTE:
Make sure that the white-dot side of the camera cable is facing up.
Figure 3-70. Replacing the Camera Module
3-54
B
C
(Figure
3-70).
(Figure
A
D
Machine Maintenance Procedures
0
3-70).