Adjusting The Remote Control Shift Cable - Yamaha SX150C Service Manual

INSP
ADJ
3120
CONTROL SYSTEM
3100
3110
2. Adjust:
• Throttle position sensor
Adjustment steps
(1) Loosen the screws 2.
(2) Adjust the position of the throttle posi-
tion sensor until the specified output
voltage is obtained.
Throttle position sensor output
voltage (pink (P) – orange (O))
0.50 ± 0.02 V
(3) Tighten the screws.
(4) Connect the throttle link rod.
ADJUSTING THE REMOTE CONTROL
SHIFT CABLE
1. Inspect:
• Shift operation
Incorrect → Adjust.
2. Adjust:
• Remote control shift cable length
Adjustment steps
(1) Disconnect the shift cable joint 1.
(2) Set the remote control lever to the
neutral position.
(3) Align the center of the set pin a with
the mark b on the bottom cowling.
(4) Adjust the position of the shift cable
joint until its hole aligns with the set
pin c.
(5) Install the clip 2 and tighten the lock-
nut 3.
WARNING
The remote control cable joint must be
screwed in more than 8 mm (0.31 in).
3-7
E
3