Download Print this page

Breville Smart Heat Control Instruction Book page 5

Panel heaters

Advertisement

• Always switch the panel heater
off on the control panel and the
main power switch at the back
of the heater, then switch off at
the power outlet and remove
the plug from the power outlet
before cleaning or storing.
• Do not operate the panel
heater on a sink or drain board.
• To avoid an electrical overload,
it is recommended that no
other appliances are plugged
into the same circuit as your
panel heater when it is in use.
• Do not use outdoors. This
panel heater is not intended
for commercial use such as
construction sites.
• Use this panel heater only as
described in this instruction
manual. Any other use
not recommended by the
manufacturer may cause fire,
electric shock or injury and
void all warranties.
• Regularly inspect the power
cord, plug, control settings, air
inlets and outlets and main
housing for any damage. If
found damaged in any way,
immediately cease use of
the panel heater and return
to Breville or an authorized
service agent for inspection or
repair.
• Do not unplug the panel
heater by pulling on the
power cord. Always unplug
using the power plug.
• Keep the panel heater
clean. Follow the cleaning
instructions provided in this
book.
IMPORTANT
SAFEGUARDS
FOR ALL
ELECTRICAL
APPLIANCES
• Fully unwind the power cord
before use.
• Connect only to a 230V or
240V power outlet.
• Do not let the power cord
hang over the edge of a bench
or table, touch hot surfaces or
become knotted.
• To protect against electric
shock, do not immerse the
power cord, power plug
or appliance in water or
any other liquid or allow
moisture to come in contact
with the part, unless it is
recommended in the cleaning
instructions.
5

Advertisement

loading

This manual is also suitable for:

Smart heat control maxLch208Lch308