Advertisement
FLOOR STANDING
The panel heater comes with detachable feet
and castor wheels which can be assembled
or not, depending on preference. The castor
wheels come with locking tabs to lock the
wheels in place.
1. If the castor wheels are not required,
unscrew from the feet before assembling to
the panel heater.
2. To assemble the feet, carefully turn the
panel heater upside down on a rug or soft
surface in order to prevent damaging the
paint finish. Align the hole found on the
bottom of the panel heater with the hole on
the centre of the feet (Fig. 6).
3. Fit the screw and tighten to secure to the
panel heater and repeat with the other foot.
4. Return the panel heater back to the upright
position.
WARNING
Do not use the panel heater without the feet
attached if it is not mounted on the wall.
OPERATING YOUR BREVILLE PANEL
HEATER
1. Place the panel heater on a flat surface if
using the feet with or without the castor
wheels fitted.
2. Insert the power plug into a 230V or 240V
power outlet. Switch on the power outlet and
press the main power switch to "I" position.
The LED display will illuminate to display
the current room temperature. The panel
heater is now ready on standby.
3. Touch the
panel. The panel heater will automatically
start in Smart Eco Mode with a default
programmed temperature of 25°C when first
turned on. The panel heater will operate on
Fig. 6
Smart ECO mode when the ambient room
temperature falls below 25°C.
NOTE
To return to standby at any time during
operation, touch the
NOTE
The LED display will dim to a comfortable level
after 15 seconds if no buttons on the control
panel is touched. For ease in programming, the
display will return to full illumination when
any operating button on the control panel is
touched.
WARNING
To avoid overheating or a fire, never cover the
panel heater.
WARNING
Do not operate the panel heater if the panel
heater has been damaged in any manner.
button once on the control
button.
13
Advertisement
