Advertisement
1. The wall bracket comes preassembled to
the panel heater and must be disassembled
to mount.
2. Pinch the tabs on the top of the two vertical
bars and pull outwards (Fig. 2).
3. Slide down the bottom of the vertical bars to
remove the wall bracket (Fig. 3).
4. Select a position on the wall to mount the
panel heater and drill holes where required
before securing the plastic anchors in the
holes.
12
5. Turn the wall bracket around so the prongs
Fig. 1
stick outwards. Using the 4 screw holes
found on the back of the wall bracket
(Fig. 4), screw the wall bracket to the wall,
through the centre of the plastic anchors.
6. Once the wall bracket is mounted firmly to
the wall, secure the raised openings on the
Fig. 2
lower back of the panel heater to the two
hooks located on the lower vertical bars of
the wall mount bracket. Push the top half of
the panel heater so the prongs on the top of
the two vertical bars are locked to the holes
located behind the panel heater (Fig. 5).
Fig. 3
Fig. 4
Fig. 5
Advertisement
