Dantel 44210 Installation & Operation Manual page 18

T B - H
ABLE CONTINUED AYES
SOFTWARE REGISTERS USED BY THE COMMAND SET
REGISTER RANGE/UNITS
S0 0-255 Rings
S1 0-255 Rings
S2 0-127 ASCII
S3 0-127 ASCII
S4 0-127 ASCII
S5 0-32, 127 ASCII
S6 2-255 Sec.
S7 1-255 Sec.
S8 0-255 Sec.
S9 1-255 1/10 Sec.
S10 1-255 1/10 Sec.
S11 50-255 m.s.
S12 2-250 1/50 Sec.
S13 Bit Mapped
S14 Bit Mapped
S15 Bit Mapped
S16 0, 1, 2, 4
F . 10 - F P V
IG RONT ANEL IEWS
44210-00
460 Modem
L
I
N
TD
E
M
DTR
O
N
OFF
RD
HOOK
CD
RING
ESD
RESET
44210-00 REV__
P 18
AGE
OPERATION
-C C S , R
OMPATIBLE OMMAND ET ESPONSE
DEFAULT DESCRIPTION
0 Ring to answer telephone on.
0 Number of rings.
43(+) Escape code character.
13(CR) Character recognized as carriage return.
10(LF) Character recognized as linefeed.
8(BS) Character recognized as backspace.
2 Wait time for dial tone.
30 Wait time for carrier.
2 Pause time caused by comma.
6 Carrier detect response time.
7 Delay between loss of carrier and hang up.
70 Duration and spacing of touch tones.
50 Escape code guard time.
none UART status register.
none Option register.
none Flag register.
0 Test modes.
The 44210 has front panel LEDs that indicate TD (Transmit
Data), DTR (Data Terminal Ready), RD (Receive Data), CD
(Carrier Detect), OFF HOOK, and RING. These LEDs will
illuminate when that function becomes active. The unit also has
front panel phone jacks, a reset button, and a subassembly
cutout window to view the front panel of an optional 49210 Two-
Line Interface Subassembly. When no subassembly is mounted
on the 44210, a bypass card is mounted in place of the subas-
sembly and a plastic insert fills the cutout opening. Refer to
Fig. 10 and Table C.
The 49210 has front panel LEDs that indicate activity for each of
49210-00
the two lines. The LEDs are designated LINE 1 and LINE 2 and
are visible through a cutout on the front panel of the 44210
LINE
1
module. Refer to Fig. 10 and Table C.
LINE
2
TWO LINE
INTERFACE
C , R U
ODES AND EGISTERS SED
44210/49210-0798 <90-00025>