Getting Started; Batteries; Change Settings - Oregon Scientific Monza FAW-101 User Manual

GETTING STARTED

BATTERIES

Batteries for the remote and main units are supplied
with this product. Replace them whenever the low
battery signal ( ) displays. Slide open the battery
door at the back of the main unit. Use a small
Phillips screwdriver to remove the remote unit
compartment lid. Be sure to match the correct
polarity, as shown in the battery compartment. After
you change the batteries, press the RESET button
with the point of a blunt object (such as a ball point
pen).
Insert the batteries in the remote unit before
you set up the main unit. Do not use rechargeable
batteries.

CHANGE SETTINGS

Press and hold CLOCK or ALARM for 2 seconds to
enter setting mode. Then, press
to change each setting. Press and hold to enter
fast-setting mode. Press CLOCK or ALARM to
switch between settings.
8
UP or DOWN