Flip Function - Reely Nanocam RtF Operating Instructions Manual

12.

Flip Function

The quadrocopter is able to fly flips as well if desired. The first flips should be flown outdoors on a wind-still day. For
this, first let the quadrocopter rise to a safety height of approx. 3 - 4 m and then let it hover.
To switch the transmitter to flip mode, push the control
lever for the nod and roll functions from above (also see
figure 1, item 4).
To indicate that the transmitter has switched to flip mode,
it will continually emit brief signal sounds.
Now move the control lever for the nod and roll function
into the direction in which the quadrocopter is to flip quick-
ly to the stop and then return the control lever to the middle
position without delay.
The quadrocopter will perform the flip in the desired direc-
tion and the transmitter will then end flip mode.
For another flip, you need to push the control lever for the
nod and roll function again.
When the LEDs at the quadrocopter flash because the flight battery has dropped below its lower voltage
threshold, the flip function is deactivated.
24
Figure 15