Table of Contents
Advertisement
Chapter 5 - Setting up the Honeywell Versatilis Signal Scout
Mounting Honeywell Versatilis Signal Scout
20
Honeywell Versatilis Signal Scout offers multiple mounting options
such as Magnetic Mount, Adhesive Mount, and Screw Mount to suit
the mounting surface of the target structure, and to ensure good
bonding and accurate measurement for the Signal Scout.
NOTE: User needs to select the suitable mounting adapter while
placing an order by referring Model Selection Guide (MSG).
The following table includes the list of recommended tools that are
required for installation/ replacement scenarios:
Tool
Spanner (for firmly holding the base
of Signal Scout while tightening the
mounting adapter to it).
Spanner (for tightening the
mounting adapter to the base of the
Signal Scout)
Allen Key and Spanner (for firmly
holding the M6 socket head cap
screw while tightening with M6 nut
respectively)
Pre-installation Considerations
Follow the below procedure when planning to install the Signal Scout
for the first time in an identified location or when you are planning to
move the installed Signal Scout from an existing location to a new
different location.
NOTE: This procedure is not applicable while replacing the
Signal Scout in the same location.
1.
Uninstall the signal scout from the existing location (in the case
of moving to a new location). For more information on how to
uninstall, see
Replacement of Honeywell Versatilis Signal Scout
(steps 1 and 2).
Size
41mm
32mm
Depends of the size of M6
socket head cap screw and
M6 nut used in the
installation.
Advertisement
Table of Contents
