Waterco OXISWIM Installation And Operation Manual page 13

When operating on chlorine, the following operating parameters are recommended:
Test
Residual sanitiser chlorine
pH level
Total Alkalinity level
Calcium Hardness
Salinity (= total Pool salt & Mineral Crystals) For low salt cell
use*
Phosphate level (ppm)
PLEASE NOTE: The above information is a guide only. Please refer to the local laws that
govern a swimming pool or spa operation in your area. Always operate the system in
compliance with local laws.
IMPORTANT: When refilling a pool, use municipal or tank water only. It is not
recommended that Bore or Well water is used to fill or top up a pool unless it has been
tested and recommended for this purpose.
OXISWIM MANUAL
Result
1.0ppm – 3.0ppm
7.2-7.6
100ppm – 150ppm
180ppm – 400ppm
2000ppm-3000ppm
Less than < 0.5ppm
P a g e 13 | 45