Page 1
ELECTROCHLOR LCD CHLORINATORS Owners Manual 25A SC Self-Clean 30A SC Self-Clean WARNING This equipment must be installed and serviced by a qualified technician. Improper installation can create electrical hazards which could result in property damage, serious injury or death. Improper installation will void the warranty.
Waterco Electrochlor LCD Chlorinators I pg 01 Electrochlor Salt Water Chlorinator The Electrochlor will automatically maintain the chlorine level of your pool and eliminate problems associated with periods of very high or low chlorine levels. Fewer fluctuations in chlorine levels mean fewer fluctuations in pH levels.
Pump Protection If no water flow is detected in the salt cell, Electrochlor automatically switches off the pump to prevent any damage to the pump and pool equipment. Indicators “FL” will start blinking on the LCD panel to alert the pool owner, until the fault is rectified. Electrochlor Salt Cell The Electrochlor’s salt cell consists of a series of titanium electrodes with opposite charges.
Waterco Electrochlor LCD Chlorinators I pg 03 Installation 1. Ensure that the chlorinator cell is the last piece of equipment installed on the filtration system – this is so the chlorine produced will not damage other equipment such as heaters.
Maintenance Although the Self-Cleaning chlorinator is designed to greatly reduce the need to clean the salt cell plates, inspection and removal of small calcium build up will be periodically required to insure correct performance. Salt Cell Cleaning Procedure 1. Press the ON/OFF button on the power pack to turn the pump and Electrochlor to standby mode.
Waterco Electrochlor LCD Chlorinators I pg 05 Chlorine Production Levels The output of the chlorinator can be adjusted to reflect the different seasonal requirements in order to maintain satisfactory chlorine sanitizer levels. The amount of chlorine produced is displayed by a bar graph, which can be adjusted by pressing the SET Level key and then by pressing the UP or DOWN keys and pressing the ENTER key to confirm.
Self Diagnostics The Bar Graph and “ F ” symbol indicates the following conditions: • F0 - The salt level may have fallen below the required level. • F0 - There is too much calcification on the salt cell plates for programmed chlorine production level.
Water Chemistry It is important to maintain the correct water chemical balance in the swimming pool; this will help protect the Electrochlor chlorinator unit and its cell. Consult the local pool professional for the correct water balance according to the swimming pool type.
Waterco Electrochlor LCD Chlorinators I pg 09 General Safety Rules 1. The equipment mentioned in this manual is specially designed for the sanitizing of water in swimming pools. 2. It is designed to work with clean water at a temperature not exceeding 35°C (95°F).
Page 12
Tel : +61 7 3299 9900 Waterco (NZ) Limited SA/ NT - Adelaide Auckland, New Zealand Tel : +61 8 8244 6000 Tel : +64 9 525 7570 ACT Distributor Tel : +61 2 6280 6476 Waterco Limited ABN 62 002 070 733 (646085) 09/2008...