Setup; Speaker Stand Installation - ION TOTAL PA ULTIMATE User Manual

SETUP

Speaker Stand Installation

1. Fully extend the speaker stand tripod legs on a flat, stable surface.
2. Raise the mounting pole up to the appropriate height needed and tighten the side
adjustment knob.
3. Insert the pin into the bottom pin-hole so the mounting pole stays at your set height.
4. On the Total PA™ Ultimate, adjust the bottom knob counter-clockwise so the screw is not
blocking the opening.
5. Line up the Total PA™ Ultimate mounting hole with the speaker stand pole and place on
the pole.
6. Tighten the mounting knob clockwise on Total PA™ Ultimate to secure it to the pole.
1
ION Audio Total PA™ Ultimate User Guide
3
2
4
5
6
5