Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ION iPA69C
Summary of Contents for ION iPA69C
- Page 1 Quickstart Guide...
-
Page 3: Box Contents
Quickstart Guide (English) Introduction 1. Make sure all items listed in the Box Contents are included in the box. Look in the box under the foam sheet for the speaker stand rubber feet, speaker stand mounting knob, power cable, and microphone. -
Page 4: Quick Setup
Quick Setup Connection Diagram Items not listed under TOTAL PA GLOW USB drive Introduction > Box Contents are sold separately. SD Card Microphones Smartphone Power Tablet Speaker Stand Installation 1. Fully extend the speaker stand tripod legs on a flat, stable surface. -
Page 5: Rear Panel
Features Rear Panel 1. Media Panel: Controls for the USB, SD, FM radio (if applicable), and Bluetooth sources. The Media Panel TOTAL PA GLOW Mode source symbol will illuminate when that source is playing. 2. USB Port: Connect your USB flash drive here to play music. -
Page 6: Media Panel
16. Clip LED: This LED will flash red if the signal from the inputs or media panel source is clipping. If this happens, decrease the setting of the Mic Input Volume knob, Aux Input Volume knob, or Master Volume knob. 17. - Page 7 Media Panel Remote Note: Aim the remote straight at the front of the speaker woofer. Room lighting and battery life can affect the operating range of the remote control. Note: In order to use the remote control for the first time, first pull out the tab attached to the battery compartment.
-
Page 8: Operation
Operation Pairing a Bluetooth Device 1. Turn on your Bluetooth device. 2. Power on Total PA Glow. 3. Use the Mode button to select Bluetooth mode, which appears as "bt" in the display. Total PA Glow will automatically go into pairing mode to search for Bluetooth devices. You will know you are in pairing mode when the Bluetooth icon is flashing.