Table of Contents
Advertisement
USER MANUAL • 13 • DUAL BMC MK III I/O UNIT SETUP (CONTINUED)
MAIN BMC Unit (1): Wire the main
channels to this BMC. Subwoofer level
trim, should be set to 0dB. Overall
system subwoofer level should be
adjusted on the AUX BMC
(via remote).
LFE gain can be set to either +10dB
or 0dB, depending on the format.
Always document all settings.
Bass-Managed + LFE
summed input from main
BMC unit. * LFE should
be set to 0dB of gain.
AUX BMC Unit (2): Wire all additional channels to
this BMC. The subwoofer output level trim should be
adjusted on this unit only (via remote).
The LFE Input gain should be set to 0dB of gain.
However, please note that to get the most LF
headroom there may be cases where the LFE gain is set
to +10dB and the SUB OFFSET on the MAIN
and AUX BMC is to -10dB.
BMC MK III
LFE Input:
+10dB or 0dB
to LFE IN
blue sky international
4.0 AMP
User Manual • Dual BMC MK III I/O Unit Setup (continued) • Page 17
Main
Aux
MAIN
AUX
to sub
R
sub 12
active subwoofer
200 watt
L U C A S F I L M
R
pm3
ON
POWER
Replace
Only
SLOW
with
BLOW
Same
Rating
120
and
VAC
AVIS: RISQUE DE CHOC ELECTRIQUE
Type
60 Hz
WARNING:
CAUTION
!
shock, do not expose this equipment to rain or
430
RISK OF ELECTRIC SHOCK
moisture. Do not remove cover. No user serviceable
DO NOT OPEN
parts inside. Refer servicing to qualified personnel.
WATTS
designed and tested in the USA
REF
100mV =90dB/1m
NE PAS OUVIR
To reduce the risk of fire or electrical
made in China
Advertisement
Table of Contents
