Polaris 650 2023 Owner's Manual page 194

DIAGNOSTIC TROUBLE CODES (DTC)
DIAGNOSTIC TROUBLE CODES (DTCS) – MATRYX
SPN = SUSPECT PARAMETER NUMBER / FMI = FAILURE MODE INDICATOR
TROUBLE CODE
Barometric Sensor
Circuit Voltage Low
Engine
Temperature
Over-Temp
Shutdown
Engine
Temperature
Sensor Circuit
Voltage High
Engine
Temperature
Sensor Circuit
Voltage Low
Engine
Temperature
Abnormal Rate of
Change
Engine
Over-temperature
Fault
Fuel Rail Pressure
Sensor Voltage
High
192
SPN FMI
108 4
110 0
110 3
110 4
110 10
110 16
157 3
P-COD-
E
caused by Damaged Wiring/Connections,
a Faulty Ambient Pressure Sensor or
ECU.
P2228 This Trouble Code Sets if the Barometric
Pressure Sensor Signal Circuit is Shorted
to Ground. Can be caused by Damaged
Wiring/Connections, a Faulty Ambient
Pressure Sensor or ECU.
P1217 This Trouble Code sets if the Engine
Temperature indicates a Critical Over
Temperature Condition and the engine is
running in a limp-home mode to prevent
damage. Can be caused by any failure
that would cause the engine to overheat.
P0118 This Trouble Code sets if the Engine
Coolant Temperature Sensor Signal is
above 4.8 Volts. Can be caused by
Damaged Wiring, a faulty Coolant
Temperature Sensor or ECU /
Connections.
P0117 This Trouble Code sets if the Engine
Coolant Temperature Sensor Signal is
below 0.1 Volts. Can be caused by
Damaged Wiring, a faulty Coolant
Temperature Sensor or ECU /
Connections.
P0119 This Trouble Code sets if the Engine
Coolant Temperature Sensor Signal is
erratic. Can be caused by Damaged
Wiring, a faulty Coolant Temperature
Sensor or ECU / Connections.
P0217 This Trouble Code sets if the Engine
Temperature indicates a Severe Over
Temperature Condition. Can be caused by
any failure that would cause the engine to
overheat. This Trouble Code Does Not
indicate a problem with the Engine
Temperature Sensor.
P0193 This trouble code sets if the Fuel Pressure
Sensor Voltage is above 4.85V. Can be
caused by Damaged Wiring, a faulty Fuel
Pressure Sensor or ECU / Connections.
CONDITION