THE PERFECT FIT
HANDLEBAR ANGLE ADJUSTMENT
1. Locate the handlebar clamp
q
at the top of the steering
post.
2. Secure the clamp bolts
with an Allen® wrench, and
loosen each of the four nuts
B
.
3. Move the handlebar forward
or backward to desired
angle.
4. Ensure that the handlebars and all components DO NOT touch the gas tank,
windshield or other part of the machine when handlebars are turned fully left
or right.
5. Torque handlebar clamp nuts to specification. Do not over-torque.
CARBIDE SKAGS
A skag is a replaceable bar attached to the underside of the ski to assist in
turning the snowmobile and to prevent ski wear caused by contact with roads
and other bare terrain. See page 159.
Do not install studs on this snowmobile. Damage will occur.
104
A
TORQUE
Handlebar Clamp Nuts
35 in-lbs (4 N·m)
NOTICE