Silvercrest SHBR 560 B1 Operating Instructions Manual page 27

Fault Cause
The fresh water
tank
The fresh water
tank
properly.
The appliance
The appliance is not
does not
completely ready for
dispensing
use.
enough clean-
ing solution.
The continuous spray
function is not activated.
The splash guard
is not fitted properly.
The rotary brush
not fitted properly.
The rotary
6
brush is not
turning.
The rotary brush
blocked.
Water is leak- The fresh water
ing from the tank
appliance. properly.
■ 24 │ GB │ IE
Remedy
Fill up the fresh water tank
q
is empty.
Filling the fresh water tank).
Take the fresh water tank
q
is not closed
appliance and tighten the lid (see section
Filling the fresh water tank).
Before each use, press and hold the cleaning
solution switch
cleaning solution to the rotary brush
so that it is ready for use.
Press the cleaning solution switch
ly to activate the continuous spray function and
continuously apply cleaning solution to the brush
roll
7
Fit the splash guard
Manual cleaning).
Switch the appliance off and pull out the mains
6
plug.
is
Fit the rotary brush
section
Remove the plug from the mains power socket.
Remove the splash guard
brush
6
Fit the rotary brush
is
back onto the appliance (see section Manual
cleaning).
Insert the plug into a mains power socket and
switch on the appliance.
Take the fresh water tank
q
is not closed
appliance and tighten the lid (see section
Filling the fresh water tank).
t
for about 10 seconds to add
6
.
7
properly (see section
6
properly onto the foot
3
(see section Manual cleaning).
6
to clear the blockage.
6
and the splash guard
q
(see section
q
out of the
6
t
twice brief-
7
and the rotary
7
q
out of the
SHBR 560 B1