Self-Cleaning Function; Manual Cleaning - Silvercrest SHBR 560 B1 Operating Instructions Manual

Self-cleaning function

The appliance has a self-cleaning function that allows you to automatically clean
the rotary brush
channel after use.
Place the switched-off appliance on the storage tray
cleaning station (see fig. 31).
Press the self-cleaning switch
Fig. 31
The following cleaning programme is started:
1. The rotary brush
applied to the rotary brush
2. The rotary brush
30 seconds while cleaning solution is applied to the rotary brush
3. The appliance will switch off automatically when the cleaning programme
completes.

Manual cleaning

For heavier soiling, it is necessary to manually clean the rotary brush
splash guard
If this occurs, do the following:
Make sure that the appliance is not plugged in.
Take hold of the top of the splash guard
and pull it forward to remove it from the foot section
■ 18 │ GB │ IE
6
, the brush chamber in the foot section
o
6
is started for approx. 20 seconds and cleaning solution is
6
.
6
turns and the vacuum function remains active for approx.
7
and the brush chamber in the foot section
4
of the parking and
(see fig. 32).
Fig. 32
7
by the edge of the handle (PULL)
3
(see fig. 33).
3
and the suction
6
.
6
, the
3
of the appliance.
SHBR 560 B1