Replacing The Lamp - Optoma DV11 User Manual

Warning: Lamp com-
partment is hot! Allow
it to cool down before
changing lamp!
Warning: To reduce
the risk of personal
injury, avoid dropping
the lamp module or
touching the lamp bulb.
If dropped, the bulb
may shatter and cause
injury.

Replacing the Lamp

The projector automatically detects the lamp life. When the lamp life
is nearing the end of use, you will receive a warning message.
When you see this message, please contact your local reseller or service
center to change the lamp as soon as possible. Make sure the projec-
tor has been cooled down for at least 30 minutes before changing the
lamp.
Lamp Replacing Procedure:
1. Turn off the power to the lamp by pressing the [Power] or
[Stand By] button.
2. Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4. Use screwdriver to remove the screw from the cover. 
5. Remove the cover. 
6. Unscrew 2 screws from the lamp module. 
7. Pull out the lamp module. 
To replace the lamp module, reverse the above mentioned
steps.
MAINTENANCE
1
2
3
4
DVD Projector 55
*