Storing The Vacuum - Simplicity S65D Owner's Manual

ASSEMBLING THE VACUUM
WARNING: The S65 battery included
can only be used with the S65 model as
intended.
Installing the Battery
Push the battery into the battery
compartment until it clicks into place
(Fig. 1).
Removing the Battery
Press the two battery release buttons
and pull the battery pack out of the
vacuum (Fig. 1).
Charging the Battery
The battery is partially charged and will
run for a short time.
1. Set the vacuum onto the Storage/
Charging Station, ensuring the
connection between points on vacuum
with Storage/Charging Station (Fig. 2).
2. Plug the battery charger into the
Storage/Charging Station and into
an electrical outlet (Fig. 3). The
indicator light on the battery will
be red while the battery is charging.
When the indicator light is blue,
the battery is fully charged (Fig. 4).
Charging time is approximately
4-5 hours.
3. Remove the battery charger from
the vacuum and begin vacuuming.
Battery Indicator Light
Solid Blue = Fully Charged
Solid Red = Low Battery
8
Fig. 1
Fig. 2
Fig. 3
Fig. 4
ASSEMBLING THE VACUUM

Storing the Vacuum

The vacuum can be conveniently stored
on the Storage/Charging Station, as well
as the wand and cleaning tools when not
in use (Fig. 1).
Both floor nozzles have a storage hook
on the back for convenient storage on
the Storage/Charging Station (Fig. 2).
The vacuum can also be stored on the
wall mount for easy access. Attach the
mount to a wall for convenient storage
(Fig. 3a). A template and screws are
provided to help you affix the wall mount
to the wall.
The vacuum can be charged on the wall
mount by plugging the charger into the
vacuum handle (Fig. 3b).
Fig. 1
Fig. 2
Fig. 3b
Fig. 3a
Fig. 3
9