Control Input - Bosch PAVIRO PVA-4R24 User Manual

18 en | Connection
minimize these reflections, these stub lines must not exceed a maximum individual length of
2 m at data transmission rates of up to 125 kbit/s, or a maximum length of 0.3 m at higher bit
rates. The overall length of all branch lines must not exceed 30 m.
The following applies:
–
–
6.5

Control input

There are two control input ports (input 1-5 or 6-10) on the rear of the device.
The CONTROL IN port is split into two halves:
–
–
The delivery includes 10-pole connectors. Conductor cross-sections of 0.14 mm² (AWG26) to
1.5 mm² (AWG16) can be used. Recommended connecting cable: shielded flexible stranded
wire, LiY, 0.5 mm². The control port is configured in IRIS-Net.
Caution!
The maximum permissible voltage on a control input is 32 V.
!
2022-11 | 07 | F01U306901
In terms of rack wiring, standard RJ-45 patch cables with 100-ohm impedance (AWG 24/
AWG 26) can be used for short distances (up to 10 m).
The guidelines specified above for the network cabling must be used when wiring the
racks with each other and for the building installation.
The upper half has five freely configurable supervised, not isolated control inputs.
The lower half has five freely configurable isolated control inputs.
User manual
PAVIRO Router
Bosch Security Systems, B.V.