Secure The Rdx Removable Disk Backup System; Mounting Hardware Used (Hp Proliant) - HP RDX USB 3.0 Removable Disk Backup System User Manual

2. Attach a spare power cable from the server or workstation's internal power supply to the
power connector.
Figure 7 Attaching USB and power cable
1 and 4
3

Secure the RDX Removable Disk Backup System

NOTE: The latches and side views of your server or workstation model may not be exactly the
same as shown in the illustrations. Please refer also to you system's documentation.

Mounting hardware used (HP ProLiant)

Ensure that you use the correct mounting rails or locating screws, as described in
hardware (page
Disk Backup System in place.
1. Push the server latch down to lock the drive into position.
2. Ensure blanking plates are in place over empty bays and replace the cover on the server.
12 Installing an HP RDX USB 3.0 Internal Removable Disk Backup System
Power cable
RDX Removable Disk Backup System
9). The server also incorporates a locking mechanism to hold the RDX Removable
2 and 5 USB cable
6 server or workstation's power supply
Attach mounting