Connecting To A Tv (Other Than European Model) - Onkyo LS-V955 Owner's Manual

Connecting to a TV (Other than European model)

Before connecting
• Refer also to the instruction manual of the TV.
• When you connect the DVD Receiver to the TV, be sure to turn
off the power and unplug both the units from the mains before
making any connections.
• Connect the DVD Receiver to the TV directly. If you connect the
DVD Receiver to a VCR, TV/VCR combination, or video selector,
the playback picture may be distorted as DVD videos are copy
protected.
I Connecting to a TV (or projector)
Using the supplied audio/video connection cable, make
audio connections from the TV/LINE IN L and R jacks to
the corresponding audio output jacks on the TV. In the
same manner, make video connections from the VIDEO
MON OUT jack to the corresponding video input jack on
the TV.
If your TV has a S video input jack and/or component video
input jacks, make S video connection to the S VIDEO MON
OUT jack using supplied S video connection cable and/or
make component video connection to the COMPONENT
VIDEO OUTPUT jacks using component video connection
cable (not supplied). These connections allow you to enjoy
higher quality picture playback. Be sure not to disconnect
VIDEO MON OUT.
Note
The signal that comes in from
S VIDEO IN is sent to S
VIDEO OUT. The signal that
comes in from VIDEO IN is
sent to VIDEO OUT.
16
TV or projector
AUDIO VIDEO S VIDEO COMPONENT
OUT IN IN VIDEO IN
R L Y P
B
REMOTE
CONTROL
ANTENNA
MON MON
2 – –VIDEO – – 1
OUT OUT
OUT IN IN
VIDEO
AM
OUT IN IN OUT
SUB
WOOFER
PRE OUT
AUDIO
FM
75
VIDEO 1 TAPE
VIDEO2
CDR/PC MD/HD
See "Turning the unit on/off with the TV's power
switch — IPM function" on page 22 for Inteligent
Power Management (IPM) function.
• Connect the plugs securely.
• Note that one audio/video connection
cable and one S video connection cable
are supplied.
Notes
• Actual labels for component video inputs may vary depending
on the TV manufacturer (ex. Y/C
• In some TVs, the color levels of the playback picture may be
reduced slightly or the tint may change. In such a case, adjust
the TV for optimum performance.
Be sure to set the digital output setting after
connection using the Setup Navigator explained in
"Setting Up the DVD Receiver" starting on page 27
or the function setting menu explained in
"Customizing the Function Settings" starting on
page 64.
Video
(Yellow)
L (White)
R (Red)
Y
P
R
P
B
P
R
DIGITAL INPUT
VIDEO 2 VIDEO 1
DIGITAL
VIDEO 2 VIDEO 1 OUTPUT
OUT IN IN
OPT
COAX
OPT
FRONT SPEAKERS
S VIDEO
R L
IN IN
L
AUDIO
R
TV/LINE
/C , Y/B-Y/R-Y, etc.).
B R
Audio/video connection cable
Component video
connection cable
S video connection cable
Signal flow
COMPONENT VIDEO OUTPUT
Y P P
B R
CENTER
SURROUND
SPEAKER
SPEAKERS
R L
DO NOT connect the
power cord (mains lead)
at this time.
Incomplete
Insert completely