Note To The Installer; Using The Flush Valve; Periodic Maintenance; Care & Cleaning - Toto EcoPower TET2GB Installation And Owner's Manual

After the Flush Valve unit has been properly installed, please explain to your customer how
to use it and tell them to observe the following instructions:
1. Do not put any object in front of the sensor window which could obstruct the sensor,
causing it to malfunction.
2. In case of any trouble, consult the troubleshooting section on p.16. If you lack the
necessary skills required or have difficulty following the directions for installation,
maintenance, repairs, troubleshooting or adjustments of the product, do not proceed
without assistance from a qualified person.
Infrared Sensor
The infrared sensor detects
a user of the toilet.
When the toilet is not used for 24 hours the protection timer commands the system to
Please check the piping to your EcoPower Flush Valve at least once a month to
avoid risk of property damage.
IMPORTANT! Do not scratch the sensor or faceplate when cleaning.
Avoid using any cleaning materials that may scratch the surface.
Never use polishing powder, detergent that includes coarse particles, thinners, benzene,
acids, alkaline detergents, or nylon scrub brushes.
To safely clean the surface, wipe it using a soft cloth dampened with diluted dishwashing
detergent and dry it with another soft cloth. If this does not adequately clean the surface,
wipe the area with a neutral detergent and wet cloth.

NOTE TO THE INSTALLER

USING THE FLUSH VALVE

Flushing
When the user stays in place
longer than 6 seconds then
moves away, the controller
sends a signal to the
operating unit to automatically
trigger the Flush Valve after
3 seconds delay.
Flushing Every 24 hours

PERIODIC MAINTENANCE

CARE & CLEANING
- 15 -
Manual Flushing Button
Use the manual flush switch
for maintenance or
emergencies.