Getting Prepared - Keysight N5242-60124 Installation Manual

Getting Prepared

Getting Prepared
a. See "Downloading the Online PNA–X Service Guide" on page
a. See "Downloading the Online PNA–X Service Guide" on page
To successfully install this upgrade kit, you will need the following:
— A license key - refer to
— A PDF copy or a paper copy of the PNA-X Service Guide - refer to
— An ESD-safe work area - refer to
— Correct tools - refer to
— Enough time - refer to
Installation Note N5242-90124
The PNA-X contains extremely sensitive components that can be ruined if
mishandled. Follow instructions carefully when making cable connections,
especially wire harness connections.
The person performing the work accepts responsibility for the full cost of
the repair or replacement of damaged components.
IMPORTANT! Before you begin this upgrade:
Verify your instrument's firmware is: A.13.55 or greater.
—
Verify your instrument's IF Multiplexer (
—
P404, P604, P804 connectors. If not, Keysight will purchase a new IF
MUX board. Refer to your instrument's Service Guide, Chapter 7
bookmark "Removing and Replacing the A20 IF Multiplexer Board" in
the PDF Service Guide
Verify your Synthesizer board is version H or greater. If not, refer to
—
Chapter A:, "Synthesizer Board Upgrade (N5240-60074 (with
Tabs)/N5240-60076 (Without Tabs) Version F/G to Version H)."
IMPORTANT!
This document contains references to legacy and new A21 HMA26.5
—
Multiplier/Amplifier assemblies. Your model instrument may have
either legacy assemblies or the new parts installed.
To verify your instrument's A21 HMA26.5 Multiplier/Amplifier, refer to
—
"Verify the Model/Version of HMA26.5 Installed" on page
See also your instrument's PDF Service Guide
—
"Downloading the Online PNA–X Service Guide"
Information" below.
IF MUX
a
.
10.
10.
"License Key Redemption"
"Step 1. Obtain a Keyword and Verify the
"Tools Required for the Installation" on page
"About Installing the Upgrade" on page
) board, has P4, P204,
9.
a
.
below.
below.
12.
11.
7