Getting Prepared
Tools Required for the Installation
Description
T-10 TORX driver - set to 9 in-lbs (1.02 N.m)
T-20 TORX driver (set to 21 in-lbs)
5/16-in (8 mm) nutsetter or open end torque wrench- set
to 10 in-lbs (1.13 N.m)
5/16-in (8 mm) nutsetter or open end torque wrench - set
to 21 in-lbs (2.38 N.m)
T-6 TORX driver - set to 6 in-lbs (0.68 N.m)
T-20 TORX driver - set to 21 in-lbs (2.38 N.m)
5/16-in (8 mm) nutsetter or open end torque wrench- set
to 8 in-lbs (0.9 N.m)
3/16-in (5 mm) nutsetter or open end torque wrench - set
to 6 in-lbs (0.68 N.m)
5/8-in (16 mm) nutsetter or open end torque wrench - set
to 21 in-lbs (2.38 N.m)
9 mm nutsetter or open end torque wrench - set to 21
in-lbs (2.38 N.m)
1/4-in (6 mm) open end wrench
Installation Note N5242-90124
Use a 5/16-in torque wrench set to 10 in-lbs on all cable connections
except the front and rear panel bulkhead connectors and the bias tees. The
bias tees should be torqued to 9 in-lbs. And, on the front and rear bulkhead
connectors, use a 5/16 inch nutsetter or open end torque wrench set to
21 in-lb.
Qty
Part Number
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
11