Advertisement
Please retain instructions for future reference
Step 4:
BEGIN BUILDING WALLS
• Place 1st layer of logs on the edges of the bearers. Ensure half logs are put down first.
See construct diagram for build order.
• Measure corner to corner diagonally to make sure cabin floor is square. If both values are equal, your frame is
square. Realign the floor until square. Do not trim.
• Screw logs into tanalised bearers using 3x S80 per log. (1x S80 in centre, 1x S80 per end notch)
• For fixing through notches.
(Detail D1)
• For fixing through half log.
(Detail D2 & D3)
• Check that floor is level using a spirit level.
1
2
2
1
S80
S80
S80
D1
D2
D3
09
Advertisement
