Advertisement
Step 13:
FELT THE ROOF -
• Roll felt out onto a clean flat surface 30 minutes before you need it so it has a chance to flatten out.
• Measure length of roof and cut each strip of felt to size. Use a straight edge to guide cutting.
• Roll cut felt piece along low side of roof, Section 1, leaving sufficient overhang to fold down onto roof edge.
NOTE: DO NOT FOLD UNDERNEATH ROOF.
• Once felt is rolled out, fix to roof using CN20 both ends, making sure felt is straight. Secure through skirting
using CN20 at approx. 100mm intervals.
• Ensure the felt is tight, secure the top side of felt using CN20 at approx. 100mm intervals.
• Trim felt to match roof ridge.
• Repeat for remaining felt, working from the low side of roof to the high side, overlapping the felt by 75mm
until the roof is fully covered. See Detail L3.
• Cut 10m length supplied into 4x lengths of 2.5m Use the 2.5m pieces to cover the ridges where the felt
overlaps. Secure using CN20 along edges of the felt at 100mm intervals.
• Use 4m to cover all felt pieces at apex of cabin. Secure using CN20 at 100m intervals.
INCORRECT FELT
13-1
13-4
MEASURE AND CUT BEFORE INSTALLING FELT
(Detail L2)
(See Step 13-1)
L1
Please retain instructions for future reference
(Detail L1 & L2)
(See Step 13-2 & 13-3)
L2
CORRECT FELT
CN20
13-2
13-5
(Detail L3)
(See Step 13-5)
(See Step 13-6)
L3
CN20
CN20
13-3
13-6
ROOF BOARD
19
Advertisement
