Table of Contents
Advertisement
2013© Overhead Door Corporation
Installation Data Sheet
1. INSTALLATION DATA SHEET
A. Your "INSTALLATION DATA SHEET" looks like Fig. 3–A. It is found
inside the door hardware box. You will need to refer to the data on
this sheet during installation. Record the pertinent data on page 7 of
this manual as a backup.
B. Verify that the "Factory Order Number" on the door components
matches the one shown on the INSTALLATION DATA SHEET.
2. PRE-INSTALLATION CHECK LIST
Ensure the door installation can be accomplished before proceeding.
• Check that the wall opening, Fig. 3–B, matches the Opening Width
and Height shown on the Installation Data Sheet.
• Check that the sill is level and plumb.
• Verify the guides you received are suitable for the jambs. Compare
the guide type on the Installation Data Sheet with Fig. 3–C.
Header
Jamb
Water Level*
Sill
Appox
Opening
5'
Width
Fig 3–B
* Laser level may also be used.
Factory Order Number
(Number shown for reference only)
Opening
Height
Level marks
Shim equal to difference
UNEVEN FLOOR (exaggerated for clarity)
www.overheaddoor.com
Fig 3–A
"Z"
Guide
Difference
"E"
Guide
Fig 3–C
608905-0007
Rev 7-03-2013
RapidSlat
Advanced Service Door
"S" Reference
(Number shown for reference only)
"G" Dimension
Middle
Angle
"S" Dimension
"G" Dimension
("G" = "S" + 1/2")
8
™
Wall Angle
Wall Angle
Outside
Angle
Advertisement
Table of Contents
