Error Messages - Onkyo HT-SR750 Instruction Manual

First Time Setup—Continued

Error Messages

While the automatic speaker setup is in progress, one of
the following error messages may appear:
Ambient noise is too high
This message appears if there's too much background
noise and the measurements cannot be performed prop-
erly. Remove the source of the noise and try again.
Speaker Detect Errors
This message appears if one of the speaker-related errors
below occurs.
• One of the front speakers has not been detected.
• One of the surround speakers has not been detected.
• The number of speakers detected on the second or
third measurement was different to the number
detected on the first measurement.
Write Error
This message appears if saving fails.
To Retry the Automatic Speaker Setup
Press the [ENTER] button.
Make sure speakers that cannot be
detected are connected properly.
38
Changing the Speaker Settings Manually
In some situations, the measurements taken by the auto-
matic speaker setup may not provide usable results. If
running the speaker setup a second time still doesn't pro-
vide usable results, you'll have to set the speaker settings
manually (see pages 53–57).
Using the Powered Subwoofer
Since the SKW-540 Subwoofer outputs very low-fre-
quency sound and its position is usually low down, it
may not be detected by the automatic speaker setup. In
this case, turn up the SKW-540's OUTPUT LEVEL con-
trol, and then try running the automatic speaker setup
again. Note that if the volume is set too high and the
sound distorts, it may not be detected, so use an appro-
priate volume level.
Note:
• If you use a subwoofer other than the SKW-540, if it
has a crossover frequency control, set it to its highest
crossover frequency. If it has a low-pass filter switch,
set it to Off or Direct. Refer to the subwoofer's instruc-
tion manual for details.