Common Functions; Setting The Display Brightness; Adjusting The Bass And Treble; Muting The Av Receiver - Onkyo HT-SR750 Instruction Manual

Common Functions

This section explains functions that can be used with any
input source.
STANDBY/ON REMOTE MODE
RECEIVER
TAPE/AMP
INPUT SELECTOR
1 2
V CR/DVR CBL/SAT
4 5
AUX MULTI CH DVD
7 8
TAPE TUNER C D
10 11
DIMMER + 10
0 CLR
D TUN ENT
--/--- DIMMER SLEEP
CH
TV VOL
DISC
ALBUM
INPUT
GUIDE
TOP MENU
SP A / B
ENTER
PLAYLIST/CAT
SETUP
LISTENING MODE
STEREO SURROUND
AUDIO SUBTITLE RANDOM
CH SEL
LEVEL -
TEST TONE CH SEL
PLAY MODE
DISPLAY L NIGHT
VCR DVD
RC - 681 M
TONE, –, +
STANDBY/ON
STANDBY
VCR/DVR CBL/SAT AUX
MULTI CH DVD
PHONES
DISPLAY DIGITAL INPUT TONE STEREO LISTENING MODE
PHONES

Setting the Display Brightness

You can adjust the brightness of the display.
Press the remote controller's
[DIMMER] button repeatedly to
select: dim, dimmer, or normal
DIMMER
brightness.
Alternatively, you can use the AV
receiver's [DIMMER] button.
Press
DVD
[RECEIVER]
M D/CDR
C D
3
first
DOCK
T V
6
9 VCR
CABLE
12
SLEEP
SAT
VOL
PREVIOUS
MENU
MUTING
MUTING
PLAYLIST/CAT
RETURN
REPEAT
LEVEL +
LEVEL – +
CINE FLTR
HDD
MASTER VOLUME
TUNING PRESET
TAPE TUNER C D SETUP ENTER RETURN
AUX INPUT
SETUP MIC VIDEO L AUDIO R
DIMMER MEMORY TUNING MODE
CLEAR
DIMMER

Adjusting the Bass and Treble

You can adjust the bass and treble for the front speakers,
except when the Direct listening mode is selected.
1 Press the AV receiver's [TONE]
TONE
button repeatedly to select either
Bass or Treble.
2 Use the TONE [–]/[+] buttons to
adjust.
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Note:
• To bypass the bass and treble tone circuits, select the
Direct listening mode.

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.
Press the remote controller's
[MUTING] button.
The output is muted and the MUTING
MUTING
indicator flashes on the display.
To unmute the AV receiver, press the remote control-
ler's [MUTING] button again, or adjust the volume. The
output is unmuted and the MUTING indicator goes off.
Muting is cancelled when the AV receiver is set to
Standby.
45