Speakers - Onkyo HT-SR750 Instruction Manual

Speakers

Subwoofer (SKW-540)
For detailed information, see the pages in parentheses.
■ Front
■ Rear
2
To AC outlet
Front, Center & Surround speakers (SKF-645F, SKC-645C, SKM-645S)
■ Rear
1
1
3
3
2
A
STANDBY/ON indicator
Red: Subwoofer in standby mode
Green: Subwoofer on
With the Auto Standby function, the SKW-540
automatically turns on when an input signal is
detected in Standby mode. When there's no input
signal for a while, the SKW-540 automatically
enters Standby mode.
B
OUTPUT LEVEL control (41)
This control is used to adjust the volume of the sub-
woofer.
C
LINE INPUT (19)
This RCA input should be connected to the sub-
woofer pre out on the AV receiver with supplied
RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
the AV receiver (page 56).
1
Keyhole slots
These keyhole slots can be used to wall-mount the
speaker.
2
Speaker terminals
These push terminals are for connecting the speaker
to your AV Receiver with the supplied speaker
cables. The supplied speaker cables are color-coded
for easy identification. Simply connect each cable to
the same-colored positive speaker terminal.
3
Speaker mount/bracket inserts
These threaded inserts can be used to attach the
speaker either horizontally or vertically to a speaker
mount or bracket.
Note:
Use commercially available 1/4" screws to attach
the speaker to a speaker mount or bracket.
17