Intended Use; Installing The Wheels - Nakayama Pro ES2510 Manual

EN
Warning: For safety reasons, the plug attached to this product must always be connected to an extension cord. The extension cord must
be suitable for outdoor use with sockets protected against water splashes. Ensure the extension cord is of the proper size and type for the
product (≥ 1.5mm2). Also, the cord should be rubber insulated, flexible, sheathed and made of polychloroprene (code designation (H05VV-F)
and its length should more than 10m.

INTENDED USE

The product is intended for reducing biodegradable, garden organic waste materials to smaller pieces, such as leaves, small branches and grass, and is used in
a stationary position by an operator standing on the ground.
This product is not intended for shredding pieces of metal, rocks, bottles, cans, etc. or soft waste such as kitchen rubbish.
It must not be used for any purposes other than those described.
ASSEMBLY INSTRUCTIONS
• Carefully remove the product and any accessories from the box.
• Make sure that no parts are missing.
• Inspect the product carefully to make sure that no breakage or damage of any sort occurred during shipping.
• If any parts are damaged or missing, do not use the machine and contact the supplier.
• Do not discard the packing material until you have carefully inspected and satisfactorily operated the product.
Warning: The equipment and packaging material are not toys. Do not let children play with plastic bags, foils, or small parts. These items can
be swallowed and pose a suffocation risk!
Warning: To avoid injury from accidental starting of the machine, always ensure that the tool is switched OFF and unplugged from the power
supply before making adjustments or installing or removing blades.

Installing the wheels

1. Insert the wheel axle (Fig. 1 - 1) through the bottom holes of the stand.
2. Install the wheels onto both ends of the wheel axle.
Secure each wheel with a nut.
3. Press the two wheel covers onto the both ends of the axle.
Assembling the stand
1. Insert the two ends of the stand assembly into the bottom of the shredder
housing (Fig. 1 - 2).
2. Align the holes and secure the two screws on both sides of the stand (Fig. 1 - 3).
Fig. 1
Fitting the paddle and paddle holder
1. Clip the paddle holder (Fig. 2 - 1) onto one side of the stand.
2. Clip the paddle (Fig. 2 - 2) into the paddle holder.
NOTE: Place the paddle back into the paddle holder every time after using.
Fig. 2
Connecting the extension cord
1. Make sure the power switch is in the OFF position.
2. Select the correct extension cord.
3. Make a knot with the power cord and the extension cord as shown in Fig. 3.
Fig. 3
5
WWW.NIKOLAOUTOOLS.GR