Hanwha Techwin SBV-120WC, SBV-160WC - Dome Camera Quick Start Guide

How to install

1. Pass the cable through the plate hole and pull it out, then install the plate at the desired installation location. (Figure 1)
   
   
   • When attaching to the Gangbox, refer to the sticker attached to the plate and fasten it to the designated screw hole. (Figure 2)
     
     
2. Connect the cable to the camera. (Figure 3)
   
   
3. Install the camera on the plate. (Figure 4)
   
   
   • The SBV-160WCW camera model can be installed in one of three possible directions. Please refer to the instructions on the sticker attached to the plate. (Figure 2)
4. Adjust the camera lens ass'y to set the setup screen.
   • When the cap is used, a rim may occur depending on the installation angle.
   • This product should be used with IR OFF. (There may be a diffused reflection of the IR LED when using it with IR ON.)
5. Assemble the Top Case. (Figure 5)
   
   
6. Assemble the cap on the plate from top to bottom and fasten two screws. (Figure 6)
   

Product Specification

Product Outline

Head Office
6, Pangyo-ro 319 beon-gil, Bundang-gu, Seongnam-si,
Gyeonggi-do, 463-400 Rep. of KOREA
Tel: +82.70.7147.8753
Fax: +82.31.8018.3740
www.hanwha-security.com

Hanwha Techwin America
500 Frank W. Burr Blvd. Suite 43 Teaneck, NJ 07666
Toll Free +1.877.213.1222 Direct +1.201.325.6920
Fax +1.201.373.0124
www.hanwha-security.com

Hanwha Techwin Europe
Heriot House, Heriot Road, Chertsey, Surrey, KT16 9DT, United Kingdom
Tel +44.1932.57.8100
Fax +44.1932.57.8101
www.hanwha-security.eu