Toro Groundsmaster 5900 Series Installation Instructions Manual page 8

6
Installing the Light Plate
and License Bracket
Parts needed for this procedure:
1 Plate light
1 License bracket
1 Sign mount
2 Screw Screw (#10 x 3/4 inch)
2 Speed nut
2
Carriage bolt (1/4 x 5/8 inch)
2 Nut (1/4 inch)
Decal (20)
Procedure
1. Remove the cover under the rear bumper
(Figure 8).
Bottom View
1. Cover under the rear bumper
2. Remove the existing warning sign and the mount
tube from the rear bumper
Note:
Do not remove the bolts from the bumper.
3. Cut the cable tie holding the wire for the plate
light.
4. Use the hardware to install the sign mount to
the bumper (Figure
5. Install the 2 speed nuts to the square in the
license bracket.
6. Install the license bracket to the sign mount with
2 carriage bolts (1/4 x 5/8 inch) and 2 nuts (1/4
inch).
Figure 8
(Figure 9).
9).
7. Route the wire to the plate light and connect it
to the light.
8. Install the plate light to the license bracket using
2 screws (#10 x 3/4 inch) and the speed nuts
in the license bracket.
1. Warning sign
2. Existing bolt
3. Sign
4. Screw (#10 x 3/4 inch)
5. Plate light
6. Carriage bolt (1/4 x 5/8
inch)
9. Adhere a sign to the license bracket
g349450
8
Figure 9
7. License bracket
8. Speed nut
9. Sign mount
10. Nut (1/4 inch)
11. Existing bolts
(Figure
g349449
9).