Toro Groundsmaster 5900 Series Installation Instructions Manual page 6

5
Installing the Headlights
(for Machines with a Cab
Only)
Parts needed for this procedure:
1 Right light bracket
1 Left light bracket
1 Right headlight assembly
1 Left headlight assembly
2 Bolt (1/2 x 1 inch)
2 Nut (1/2 inch)
2 Bolt (1/4 x 3/4 inch)
2 Nut (1/4 inch)
2 Grommet
Procedure
1. Unplug the wire harness from each existing
headlight.
2. Remove the headlights and retain the hardware.
3. Remove and discard the existing bracket.
4. Install the grommets to the light mounts.
5. Install each headlight bracket to the cab frame
using 1 bolt (1/2 x 1 inch), 1 nut (1/2 inch), 1 bolt
(1/4 x 3/4 inch), and 1 nut (1/4 inch) as shown
in Figure 7.
6. Remove the fasteners from the headlight
assemblies and use them to install the
headlights to the brackets.
7. Route the wire harness through the bottom of
light brackets and out the grommets.
8. Connect the wire harness to each headlight
(Figure 7).
6