Operation; Aiming The Headlights - Toro Groundsmaster 5900 Series Installation Instructions Manual

8
Verifying that the Machine
is in CE Mode
No Parts Required
Procedure
1. Start the machine.
2. From the InfoCenter main menu, navigate to the
About screen (Figure
3. Verify that the machine is in CE mode. If it is
not in CE mode; contact your authorized Toro
distributor.
11).
Figure 11

Operation

Using the Light and Hazard
Switches
•
Turn the key switch on and press the light switch
to the O position to activate the head lamps.
N
•
Press the hazard switch to the O
activate the front and rear flashing hazard lights.
•
Turn the key switch on and press the left side of
the turn signal switch to activate the left turn signal
and the right side of the switch to activate the right
turn signal. The center position is off.
Note:
Check the operation of the lights. Make
sure that the correct lights are flashing when
operating the turn signal switch.

Aiming the Headlights

1. Loosen the mounting nuts to adjust the lights.
2. Adjust the lights per local standards.
g188853
11
position to
N