Toro Groundsmaster 5900 Series Installation Instructions Manual page 5

4
Installing the Headlights
(for Machines with ROPS
only)
Parts needed for this procedure:
1 Right light bracket
1 Left light bracket
2 Grommet
Procedure
1. Unplug the wire harness from each existing
headlight.
1. Existing headlight
2. Grommet
3. Previously removed bolt
4. Previously removed washer
2. Remove the headlights and retain lights and
hardware.
3. Remove the brackets from the headlights and
discard the brackets
4. Using the fasteners that you removed, install the
left and right light brackets to the existing holes
in the front of the operator's platform
5. Using existing fasteners from the headlight
assembly, install the headlights to the left and
right light brackets
6. Install the grommets to the light mounts
6).
7. Route the wire harness through the bottom of
the light brackets and out the grommets.
8. Connect the harness to each headlight.
Figure 6
5. Remove and discard the existing bracket.
6. Left light bracket
7. Right light bracket
5
(Figure 6).
(Figure
(Figure 6).
(Figure
6).
g349448