Toro Groundsmaster 5900 Series Installation Instructions Manual page 4

3
Installing the Wire Harness
Parts needed for this procedure:
1 Wire harness
1 Switch
1 Auxiliary-brake decal
Procedure
1. Remove the 6 bolts from the console and
remove the panel
1. Turn-signal switch
2. Hazard switch
2. Disconnect the connectors from the hazard
switch and turn-signal switch
3. Remove the knockout from the control panel
and install the switch
(Figure 3).
Figure 3
3. Panel
4. Bolt (6)
(Figure 3).
(Figure 4).
1. Switch
2. Auxiliary-brake decal
4. Adhere the auxiliary-brake decal above the
switch (Figure
5. Connect the new wire harness to the hazard
switch, turn-signal switch, and auxiliary-brake
switch (Figure
g186692
1. Connect to the
auxiliary-brake switch.
2. Connect to the turn-signal
switch.
3. Connect to the hazard
switch.
6. Connect the wire harness to the machine main
wire harness inside the console
7. Install the panel
4
Figure 4
3. Knockout
4).
5).
Figure 5
4. Connect to the main wire
harness.
5. Connect to the EU Light
Power connector on the
main wire harness.
(Figure
(Figure 3).
g186717
g349451
5).