Programming Favorite Channel Scan - One for All URC-4021 User Manual

CTGAE4P 4021 manual booklet
2.
3.

PROGRAMMING FAVORITE CHANNEL SCAN

In the or
CBL/SAT
in any order, that will be immediately scanned when
Using Channel Scan
NOTE: Favorite channels can only be programmed for one mode. After programming, if FAV
is pressed while in another mode, the remote control will start scanning all channels instead
(if applicable to the selected device).
1.
2.
3.
4.
5.
6.
Press once.
FAV
• If Favorite Channel Scan has been set up,scanning of
favorite channels will start with up to 100 channel changes
or until stopped by pressing any key.
• If Favorite Channel Scan has not been set up, scanning
will start with the current channel, and continue up to
100 channel changes or until stopped by pressing any key.
To stop scanning channels at any time, press any key
once.
mode, you can store a list of up to 10 favorite channels,
TV
on the previous page).
On the remote control, press
Press and hold until the
SET
then release .
SET
Enter - - . The
9 9 6 LED
Use the keypad to enter a favorite channel number (e.g.,
). Then press
031 SET
NOTE: If the original remote control required pressing an Enter key
to change the channel, also press the ENTER key after the channel
number (e.g., 0 - 3 - 1 - ENTER). On some satellite receivers and cable
boxes, you may need to press the SELECT (OK) key instead of ENTER.
If desired, repeat step 4 for each channel to be stored, up
to a total of 10 channels.
NOTE: If you try entering more than 10 channels, the remote control
will automatically exit programming. To change your favorite chan-
nel list at this point, you will first need to delete the existing list by
performing the steps in "Clearing Custom Programming" on page 14.
Then, perform the instructions in this section once again.
To exit programming with less than 10 favorite channels
stored, press and hold
Otherwise, the remote control will automatically exit the
program after 10 channels have been stored.
12
5/24/04 12:10 PM
is pressed (see
FAV
or
CBL/SAT TV
(red light) blinks twice,
LED
will blink twice.
once.
until the blinks twice.
SET LED
Page 12
once.